Why You Should Focus On Making Improvements To Peugeot 308 Key Fob

· 4 min read
Why You Should Focus On Making Improvements To Peugeot 308 Key Fob

Peugeot 308 Key Fob Replacement

Peugeot's 308 could be catching on a bit however it's still appealing. It's not the most luxurious car in its class, but it's a relaxing and civilised drive.


We are often asked at Coded Car Keys to replace peugeot key fobs. If the issue is intermittent or constant these tips will assist.

Water Damage

If you leave your key fob in a pool or get it wet when kayaking, swimming, canoeing, rafting, or canyoning, it's probably to sustain water damage. The best way to stop this from happening is to keep it in a dry, dry bag when you're outdoors or performing activities that require the fob to be exposed to high levels of water.

You should also make sure that the fob is completely dry prior to opening it and reusing it. If you notice any odors coming from the fob, like an industrial liquid smell or that of windshield washer fluid, this is another indication that it's submerged in water.

A wet circuit board can cause the battery to discharge its charge, or even explode. If you are able to get your 308 keyfob out of the water it is best to turn the button side up and shake as much water as possible before opening the casing. Remove the battery, then clean the circuit board using a cotton swab which has been dipped in 90-percent alcohol.

Other reasons why your Peugeot 308 remote entry keyless system might not work include a dead coin cell battery or receiver module issues signal interference or a defective chip. If none of the above is the issue you can reset the system by disconnecting a 12 Volt battery from the car for 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote start system that lets drivers start their car from an extended distance, which allows them to warm up or cool down the vehicle before they get in. This feature is extremely beneficial, especially during winter's cold and chilly months. The remote start system may be stopped for a variety of reasons, including an inactive coin-battery.

A coin-shaped battery that is located inside the key fob has a life span of between two and four years, based on how frequently it is utilized and where it was purchased. The date for use-by is typically printed on the package or written in the manual.

If the key fob has stopped functioning after being exposed to pure tapwater, you need to remove the battery and clean the electronic chip with a paper towel soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing it. If  peugeot 107 replacement key  expose it to soapy or salty water, the chip might be damaged and you'll require replacing the key fob altogether.

If you're unsure if the battery is in good condition You can test its voltage using a multimeter that is set to the vehicle's voltage range and connected to the terminals for minus and plus. The voltage should range from 12-13 volts, but if it is lower, the battery must be replaced. Alternately, you could try to reset the onboard computer by disconnecting the 12 volt battery for a few minutes and then reconnecting it in reverse order (positive cable first, then negative). The engine should now start.

Faulty Receiver Module

If you're not seeing the "Key Detected" message on your dashboard, it's possible that the receiver module has discovered a problem. It's the part that transmits an alert when the key fob goes off. It also acts as an alarm that stops the vehicle from starting without the correct key.

The cause could be many reasons, such as water damage or just getting old. If your Peugeot 308 key fob has been exposed to dirty tap water, for example the chip that is located inside may be damaged. In this instance it is necessary to take off the battery and thoroughly clean it with isopropyl alcohol or electronic cleaner. Once the battery is dry you can attempt to test it again.

If the problem persists, it's probably a good idea to seek out a local Peugeot specialist or locksmith. They'll utilize a diagnostic tool to help pinpoint the issue and fix it.

It can be a stressful experience to lose your Peugeot car key. However, a professional auto locksmith can address the issue in only a few minutes. They can program your car and cut a new working key for you. Click here to find a locksmith in your area.

Faulty Electronic Chip

The chip in the Peugeot 308 key fob plays a crucial part in the remote control system. If the chip is damaged, you could be unable to start your car or receive a message that says "anti-theft". If this happens, the only way to fix the problem is to purchase a new key. Fortunately, auto locksmiths with experience are able to provide this service in the shortest time.

The chip inside your Peugeot 308's key fob could fail due to a variety of reasons, including sweat, water damage or dirt. If your Peugeot key fob was exposed to soapy or dirty water, it should be cleaned as soon as possible. You can clean the electronic component using a paper towel soaked in isopropyl Alcohol. After that, allow the battery to dry completely.

Sometimes keys may cease to function due to radio interference. This can happen when other devices operate on the same frequency as your Peugeot keyfob. This could be due to bad conditions or objects within the vicinity of the vehicle. It is recommended to visit a Peugeot dealer if you have this issue.

The Peugeot 207/308 key fob is extremely delicate and requires extra care. You should not drop it or throw it around. If you lose it, try to find it as quickly as is possible. You can reset all the on-board computers by disconnecting the 12 volt battery for a few minutes. Disconnect the negative cable prior to the positive.